您好,歡迎訪問廣西重工液壓升降設備廠官網!
1、用電阻檔檢查升降貨梯http://m.olymzig.com/線路時,需要把電源斷開,然后通過電路原理圖進行測量,根據測量出的電阻值的大小,來對故障點進行分析。
When checking cargo lifter with resistance profile line, you need to power off, and then measured by the circuit diagram, according to the size of the measured resistance value, to analyze the point of failure.
2、用短路的方法檢查升降貨梯http://m.olymzig.com/線路時,可以以移動式升降機的控制原理圖為依據,對可能出現的故障觸點、開關等進行短接,短接后,如果故障消除了,就說明故障在這部分,縮小范圍后,再進行檢查,就可知道故障點在哪里。
When cargo lifter lines can control schematics based mobile lifts for possible fault contacts, switches, etc. Short shorts with a method to check, after a short circuit, if the fault is eliminated, it means failure in this part of the narrow range, and then check, you can know where the point of failure.

公司名稱:廣西重工液壓升降設備廠
聯系人:鄭經理
手機號:18878881055
座機:0771-3366627
郵箱:584649766@qq.com
地址:廣西南寧市青秀區仙葫經濟開發區開天路23號
手機移動端
微信掃一掃